This device is designed to crush tires into blocks of 50 x 50 cm for further processing. It is formed with in feed funnel, motor, gear transmission system, crushing chamber, classifier, main body. Working principle: The blades in the crushing chamber are driven turning by the main motor to shear the tires with outer diameter less than 1.2m from the in feed funnel. During the shearing process, blocks less than or equal to 50 x 50mm are filtered out through the screen, bigger size will be send back for crush again until smaller than the above mentioned size. Advantages: 1. Double shaft shearing method optimizes the drive force and avoids jam and meanwhile reduces the moment of overturning 2. Cycloidal-pin gear speed reducer planetary reducer features high working capacity, high efficiency, low noise, low volume and long lifetime 3. Horny alloy blade edge can be shaped several times to ensure long lifetime for blade 4. Easy shaft replacement and maintenance

Waste Tire Recycling Equipment Working Princeple: The motor by the shaft coupling impetus oil pump to high-speed processing, provides the high-pressure oil, leads the piston rod to reciprocal motion. When The equipment starts moving, the cylinder impetus the blade stretches, installed on the car, out of the tire back plate, then hangs the inner loop of one side of the tire onto the knife cancels, after that the knife retracts in the tire back plate by the cylinder impetus, under the guidance function of the guidance board, depending upon the knife, the cutting edge bead the tire. Advantages: 1. The cutter body uses the high quality alloy steel plate, the guidance surface and the cutting edge uses the antifriction metal welding rod of high degree of hardness. The service life is long. 2. The tire imposition is easy, the knife reciprocation power stroke is short, the equipment output is high. 3. Two workings: Manual and the automatic method, the operation is simple. 4.